mirkoj
November 5, 2009, 4:32pm
1
Hello!
Slave Log
Path IS there and I open it and look in the folder and yet deadline is sending message that path is not there. Any idea?
Can you post the full render log for this task? You can find the render log by right-clicking on the job and selecting Job Reports -> View Log Reports.
Thanks!
mirkoj
November 5, 2009, 4:59pm
3
Here it is:Brazil Console. ”MSP Acceleration. ”FumeFX:. ”FumeFX Dynamics:. ”Maxwell Translation Window. ”VRay authorization. ” by pressing “Cancel”V-Ray warning. ” by pressing “OK”File Load: Units Mismatch. ” by pressing “Adopt the File’s Unit Scale?;OK”Frame Rate Change. ” by pressing “OK”MAXScript Auto-load Script Error. ” by pressing “OK”Render history settings. ” by pressing “OK;No”Warning - the software has encountered a problem. ” by pressing “Don’t show me this error again;Continue”Frantic Films FPS Watchdog. ” by pressing “OK”Missing Dlls. ” by pressing “Cancel”
0: INFO: Executing script: C:\Users\mirko.jankovic\AppData\Local\Frantic Films\Deadline\slave\plugins\customize.ms#1 )#120 )#122 )#123 )#120 )#124 )#4 )#5 )#117 )#119 )#54 )#6 )#7 )#8 )#9 )#10 )#6 )#11 )#115 )#116 )#118 )#114 )#12 )#13 )#126 )#125 )#14 )#128 )#127 )#41 )#15 )#15 )#1277 )#130 )#14 )#129 )#14 )#3 )#42 )#12 )#11 )#127754 )#132 )#16 )#131 )#127754hgc )#134 )#133 )#1 )#2 )#3 )#2 )#2 ): done [00:00:01.5]
Log Details
Slave Machine = Mirkoj
Plugin Name = 3dsmax
Now reading this it looks like my comp can’t find destination folder but I can open it without any problems. Also rendering from max works just fine.
Thanks! The final output location that Max will be saving to is Y:\IGOR LOVAC\10 Render\Kastel_101\Kastel_101_02\kastel_101_02_.rpf. Can you confirm that the path is valid and that your render nodes have the necessary permissions to write to this location?
Cheers,
mirkoj
November 5, 2009, 5:25pm
5
Yep, location is there and permissions set up. Could it be that Guest user account is used by deadline and that account maybe don’t have permission or even more likely that drives should be mapped there as well?
Just to back up a bit, did you install the Client as a service? This was an option during the Client installation. If so, then you will need to configure Deadline’s Mapped Drive Setup so that the service can map the path before rendering. You can find this in the Monitor while in super user mode by selecting Tools -> Configure Repository Options. Then select Mapped Drive Setup from the list on the left.
Whether you have the Client installed as a service or not, any paths that you’re using from your workstation should be identical on your render nodes. So if a path is mapped to Y: on your workstation, but is mapped to X: on your render nodes, then you’ll run into problems because to them, Y: doesn’t exist.
Cheers,