Hierarchy

Discussion and Support of XMesh, the Geometry Caching System
User avatar
im_thatoneguy
Posts: 1805
Joined: Tue May 20, 2008 2:18 pm
Location: Seattle, WA
Contact:

Hierarchy

Postby im_thatoneguy » Wed Nov 01, 2017 2:04 pm

When XMesh creates an XMesh object from the saver, it fails to parent the new XMesh Object to the saved object's parent.
Gavin Greenwalt
Gavin[47]SFStudios.com
im.thatoneguy[47]gmail.com

User avatar
Bobo
Posts: 6128
Joined: Tue Nov 15, 2005 10:26 am
Location: Vancouver, Canada
Contact:

Re: Hierarchy

Postby Bobo » Wed Nov 01, 2017 2:17 pm

I was unable to reproduce this in a simple test. Can you provide a simple scene that showcases the issue?

I did this:

* Created a Cylinder, added a Bend modifier, animated Bend angle over time
* Created a Sphere, animated the position of the Sphere.
* Parented the Cylinder to the Sphere, resulting in both translation and bending animations.
* With the Cylinder selected, opened XMesh Saver.
* Set the Save mode to OBJECT SPACE
* Made sure an XMesh Loader will be created
* Under Advanced rollout, switched the "When In Object Space" drop-down list to "Link to Source's PARENT".
* Saved the Cylinder to an XMesh sequence over 101 frames.

RESULT: The new XMesh Loader was parented correctly to the Sphere, and matched the animation of the original parented Cylinder.

* Switching the saving mode to a World Space option disables the parenting, since the "When In Object Space" list obviously requires object space.

However, it is possible that this mechanism fails in more complex scenes, so if you can provide one that illustrates the issue (preferably saved after an XMesh Saver session so I can access the XMesh Saver History), it would be very helpful!
Borislav "Bobo" Petrov
Product Specialist
Thinkbox Software Inc.


Return to “Thinkbox Software - XMesh”

Who is online

Users browsing this forum: No registered users and 2 guests