When I use the PRT Source, the position of the PRT Source output has the Z scaled by half. So everything looks squished relative to the input object.
2.1.2.47756, 2012 x64
Pic plz? I’m sure I can figure it out, but if you can describe the problem visually it will go quicker.
Grrr… I can’t get it to do it now. It was happening all the time before…
But what I AM noticing is that if I have a Magmamodifier…
So Teapot -> PRTVolume -> PRTSource. Put a MagmaFlow on the PRTVolume that does Position -> Multiply (1,1,2) -> Position, the PRTSource is ~.5 the correct size in Z. Whew! So it looks like the PRTSource caches something when using the MagmaFlow that is different than if the PRTVolume just had an XForm that was set to scale up (the XForm causes the PRTSource to update just fine).